Loading
Página InicialBloguesArtigo #38600Comentários

Comentários • Peg problem advice?

  • FirstAnterior12PróximoLast
    15 comentários
  • 19pt
    It's honestly just a very minor fault. I don't see why you would be so upset over it. If you take the figure off the base and put it back on a few times and push a little harder it should be fixed, at least, that worked for me. :)
    1 mês atrás
    1pt
    Have you tried heating the feet with an hair dryer and then putting it on the peg? Be careful though, don't make it burning hot!
    1 mês atrás
    1pt
    kyoshinhei (1 mês atrás) #29459696I don't own this particular figure but I've had at least one figure from Alter that looked like it had the same problem.
    Turned out I just needed to push quite harder for the last few millimeters and then it fit just right.
    I'd wait for comments from actual owners of this figure to see if that is also the case here.
    warriorofdream (1 mês atrás) #29460305I had similar issue with my Alter figure, also it ause me sadness in first few minutes, I couldn't fit peg into hole at all then I turn figure a bit, push it harder, so I guess maybe you should give it a try too?

    Thank you both for your input! I’ll try this later since I put her back in the box for now but I’m holding on to that glimmer of hope that I didn’t get a defect ^^
    1 mês atrás
    1pt
    kyoshinhei (1 mês atrás) #29459696I don't own this particular figure but I've had at least one figure from Alter that looked like it had the same problem.
    Turned out I just needed to push quite harder for the last few millimeters and then it fit just right.

    I had similar issue with my Alter figure, also it ause me sadness in first few minutes, I couldn't fit peg into hole at all then I turn figure a bit, push it harder, so I guess maybe you should give it a try too?
    1 mês atrás
    2pt
    I don't own this particular figure but I've had at least one figure from Alter that looked like it had the same problem.
    Turned out I just needed to push quite harder for the last few millimeters and then it fit just right.
    I'd wait for comments from actual owners of this figure to see if that is also the case here.
    1 mês atrás
  • FirstAnterior12PróximoLast
    15 comentários
Where the fun begins!